Stance, Hot and NOT!

[SnakeByte]

549550
Those rear wheel spacers that I installed last year make the Cobra look sick from behind but when looking at it from the side, all that space above the DR's is looking pretty gay?

Any suggestions on a sping kit to drop it maybe 1.5 " or so? Anyone done this before? How big of a PIA is it?

Thiking about picking up these bad boyz here:

http://cgi.ebay.com/ebaymotors/H-R-Race-Springs-03-04-Cobra_W0QQcmdZViewItemQQhashZitem439e4abfbfQQitemZ 290418507711QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAc cessories

TIA.....

[HELLFYR]

H&R Race springs and a set of Maximum Motorsports caster campler plates. Dropped mine an inch and a half in the rear and a little over that in the front.
Left only the upper isolators in. Car handles much better now too with the increased spring rate.

Rod

[SnakeByte]

H&R Race springs and a set of Maximum Motorsports caster campler plates. Dropped mine an inch and a half in the rear and a little over that in the front.
Left only the upper isolators in. Car handles much better now too with the increased spring rate.

Rod

How long did the install take? How many times did your cuse during the install?

Thanks for your input Rod!